walther cocking pin

Discussion in 'General Airgun Chat' started by Ratinator, May 9, 2013.

  1. Ratinator

    Ratinator 77.74

    Joined:
    Jan 2, 2010
    Messages:
    2,699
    Location:
    stourport
    Club:
    Millride FTC / Nomads
    I'm looking to replace the pin that pull's the hammer back when cocking,can any tech guy's tell me if a roll pin of the correct diameter will be ok for this application.
    thanks simon
     
  2. TOOL

    TOOL Independent FT Pumper

    Joined:
    Mar 4, 2009
    Messages:
    1,637
    Location:
    Humber Bridge , Barrow-on-Humber in Bomber County
    Club:
    EFTA England
  3. Ratinator

    Ratinator 77.74

    Joined:
    Jan 2, 2010
    Messages:
    2,699
    Location:
    stourport
    Club:
    Millride FTC / Nomads
  4. Jon

    Jon Member

    Joined:
    Nov 1, 2008
    Messages:
    758
    Location:
    Nr Wolvo
    If your stuck for Sunday I can rob one from a Tesro.
     
  5. fireblade

    fireblade Team AirArms

    Joined:
    Mar 21, 2009
    Messages:
    722
    Location:
    liverpool
    Club:
    Tawd Vale FTC
  6. Ratinator

    Ratinator 77.74

    Joined:
    Jan 2, 2010
    Messages:
    2,699
    Location:
    stourport
    Club:
    Millride FTC / Nomads
    pieman

    I'm trying to hit tin chickens not make chicken pie's.
     
  7. TOOL

    TOOL Independent FT Pumper

    Joined:
    Mar 4, 2009
    Messages:
    1,637
    Location:
    Humber Bridge , Barrow-on-Humber in Bomber County
    Club:
    EFTA England

    Are you sure ?
     
  8. ellis d

    ellis d Active Member

    Joined:
    Jan 28, 2012
    Messages:
    952
    Location:
    Leicester
    Club:
    Castle ftc
    A rusty nail would do the job....;) more than good enough for you simon:D
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice