TX Safety Catch

Discussion in 'General Airgun Chat' started by Lord Long, Aug 28, 2014.

  1. Lord Long

    Lord Long Back after 20 years

    Joined:
    Mar 30, 2014
    Messages:
    38
    Location:
    Margate
    Want to put a brass safety catch on my TX, question before I start, do I have to take the whole trigger block out ie both pins or can I get away with just the back one and swivel it down ?
    Cheers.:)
     
  2. Lord Long

    Lord Long Back after 20 years

    Joined:
    Mar 30, 2014
    Messages:
    38
    Location:
    Margate
    Just in case anyone is interested" I did get the new safety fitted.
     
  3. chris

    chris New Member

    Joined:
    Jul 31, 2014
    Messages:
    8
    Location:
    Blackpool
    Club:
    Emley Moor FTC, Blackpool RPC
    How was the job of fitting it?
     
  4. Lord Long

    Lord Long Back after 20 years

    Joined:
    Mar 30, 2014
    Messages:
    38
    Location:
    Margate
    It's not that difficult...unless like mine the longer of the 2 pins that hold the trigger unit to the block won't come out, I used the correct punch, tapped lightly (as advised by a youtube clip) hit it harder...and harder...where's the club hammer, ok not quite that bad, eventually out it came, on fitting the catch would it go back in...would it. **** the hollow pin it fits through wasn't really big enough! I had to run a drill bit through it.
    All OK now, if you don't have the problem I had (I'm lucky like that) it's a piece of cake.
    Looks good now fitted. Just need Rowan to get their finger out and make some more brass set back triggers.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice