reg creep

Discussion in 'Steyr' started by blacklab, Aug 25, 2018.

  1. blacklab

    blacklab Active Member

    Joined:
    Aug 12, 2012
    Messages:
    647
    Location:
    pontypridd
    Club:
    nelson
    got a digi gauge attached to my reg checker set reg to 85 bar its creeping a little bit, every thing new inside except for piston there is a witness mark on the plastic tip of the piston, will this little bit of creep settle down after a little use when a newer witness mark is made, just a thought
     
  2. blacklab

    blacklab Active Member

    Joined:
    Aug 12, 2012
    Messages:
    647
    Location:
    pontypridd
    Club:
    nelson
    anybody
     
  3. RobF

    RobF Administrator Staff Member

    Joined:
    Mar 4, 2010
    Messages:
    12,701
    Location:
    New Forest, Hampshire
    Club:
    Parkstone Gun Club, South Dorset FTC, Southampton Buccaneers
    Unlikely.

    Hmanphilly is the man to sort them.
     
    ksts100 likes this.
  4. dave croucher

    dave croucher FT, the sport where simple becomes complicated

    Joined:
    Aug 27, 2009
    Messages:
    556
    Location:
    dartford
    Personally, I think you should all leave Reg alone .
     
    nat and terryn like this.
  5. BDL

    BDL Dangerous

    Joined:
    Apr 6, 2013
    Messages:
    1,003
    Location:
    Ebbw Vale
    Club:
    Blaenau Gwent
    Check the washers are all sitting nice, and the piston is seated correctly mate. Had an issue with one I'd done took it apart again and re seated everything and it was fine after that.
     
  6. hmangphilly

    hmangphilly Floppy Quick Phil

    Joined:
    Nov 5, 2013
    Messages:
    2,464
    Location:
    wimborne

    Lay orf ........

    IMG_3545.JPG
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice