Leaking anschutz 2002 advice needed

Discussion in 'General Airgun Chat' started by sticko, Sep 15, 2014.

  1. sticko

    sticko Member

    Joined:
    Feb 17, 2013
    Messages:
    44
    Location:
    grays essex
    Club:
    etl
    Evening gents looking for some advice ' I have an anschutz 2002 that is loosing all of its air further investigation using the ballon method proved it to be the filling valve not only from the end nearest the nipple( ball bearing) I am handy so changing it should not be a problem once I have drained the air my question is where can these valves be purchased from ie are they a generic valve. Or a special from anschutz it is the old daystate type adaptor your help would. Be much appreciated Pete ps I am in grays essex so may be t r robb will stock them if any one could help
     
  2. holly

    holly Well-Known Member

    Joined:
    Nov 8, 2008
    Messages:
    2,849
    Location:
    ISLE OF WIGHT
    Club:
    carisbrooke rangers
    Best

    I think that Best Fittings would be your answer . they have all the filler fittings including theDaystate/ Ripley one > cheers HOLLY

    PS they are on the internet :)

    PSS if desperate . as you live in grays . if you go up the old london road under the dartford bridge . as you go past it after about half a mile on the right is a hydraulic fittings place in a small estate . they do all sorts of fittings ?
     
    Last edited: Sep 15, 2014
  3. sticko

    sticko Member

    Joined:
    Feb 17, 2013
    Messages:
    44
    Location:
    grays essex
    Club:
    etl
    Many thanks for that Holly I will try them tomorrow
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice