UKAHFT Hoping for a good final round of the 2018 UKAHFT nationals at Quarry?

Discussion in 'UKAHFT Official Forum' started by Tone, Oct 14, 2018.

  1. Tone

    Tone Active Member

    Joined:
    Apr 29, 2010
    Messages:
    759
    Location:
    Bristol
    Club:
    Bristol Aero & Quarry Hunters
    Quarry is the last round next Sunday and we have been braving the wet today to start setting out the course.

    I have seen the line that Pete has set out and will complete during this week, and it is probably the most challenging I have ever seen up there :confused: and has never been done before :eek:

    If you are depending on a good round next week then you better dust off your mildots because you are going to need them :D:p
     
    bow, subaru swift, pbrown and 5 others like this.
  2. Ceathreamhnan

    Ceathreamhnan WHFTA Champion 2013

    Joined:
    Nov 14, 2011
    Messages:
    820
    Location:
    Stirling
    Club:
    Dunfermline
    IF there is quarry wind ;)
    And Pete says he never sets a course for wind ‘cos if so there never is any :D
     
  3. poth

    poth Whafta old Gits world champion

    Joined:
    Nov 20, 2011
    Messages:
    660
    Location:
    Tredegar
    Club:
    Quarry hunters hft
    The course is out ready to welcome all .new line not shot before even for quarry members
     
  4. Sparky

    Sparky Ich dien Staff Member

    Joined:
    Nov 8, 2008
    Messages:
    2,644
    Location:
    Pontypool South Wales
    Club:
    Quarry Hunters
    Hi all

    Please be aware due to the weather we have had and course layout there will be a very limited plinking range, so make sure your guns are on:)
    Also with the parking any 4x4 can you park somewhere to the right of the gate when you come in and all others to the left up to the blue rope.

    Cheers
    Pete
     
  5. subaru swift

    subaru swift I don't have a solution, I just love the problem.

    Joined:
    Apr 2, 2010
    Messages:
    639
    Location:
    stoke on trent & bromsgrove
    Club:
    Kingsley HFT & Furnace mill.
    Cheers Tony, I'm really looking forward to this one mate... :)
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice