EV2 trigger pictures/help

Discussion in 'General Airgun Chat' started by Splund, Sep 4, 2013.

  1. Splund

    Splund New Member

    Joined:
    Dec 4, 2010
    Messages:
    11
    Location:
    West Sussex
    I have just bought an EV2 but the trigger feels a little wierd.
    All looks OK but if anyone has a decent picture of what the EV2
    trigger mech looks like that would be great.
    Just a shot of the trigger block with the side plate removed.
    The main problem I have is the black cocking arm, top left, dosent
    seem to have a return spring. When the gun is cocked and the lever
    is pushed forward so the probe enters the barrel, the black cocking remains
    in the rear position, resting against the hammer.
    This causes inconsistent low powered shots. Is there supposed to be
    a return spring?
    I realise the brass spacer washer is not fitted on the arm
    Bob

    http://i1262.photobucket.com/albums/...psece5a1d8.jpg
     
  2. cozypom

    cozypom New Member

    Joined:
    Jan 24, 2012
    Messages:
    93
    Location:
    bideford
    Club:
    North Devon Airgunners
    ev2 trigger

    have a look on my profile m8 theres a step by step trigger assembly on there:)
     
  3. ellis d

    ellis d Active Member

    Joined:
    Jan 28, 2012
    Messages:
    942
    Location:
    Leicester
    Club:
    Castle ftc
    You need part number RN295-cocking plate spring and RN282- cocking plate outer spacer, looking at the cocking plate I would get a new one, RN275FT-cocking plate...hope this helps:)
     
  4. Splund

    Splund New Member

    Joined:
    Dec 4, 2010
    Messages:
    11
    Location:
    West Sussex
    Thanks for that Ellis, I have PM'd Julian Bond.
    Should be sorted soon.
    Bob
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice