Daystate GP - wiring diargram

Discussion in 'Daystate' started by wyan, Dec 19, 2011.

  1. wyan

    wyan New Member

    Joined:
    Aug 11, 2009
    Messages:
    11
    Location:
    South Africa, PRETORIA
    Anybody that can help me with above please, try to fault find why the chrony is not working.

    Regards
    Wyan
     
  2. brianf51

    brianf51 Fort AGC

    Joined:
    Aug 19, 2010
    Messages:
    86
    Location:
    Chester
    Club:
    Fort AGC
  3. wyan

    wyan New Member

    Joined:
    Aug 11, 2009
    Messages:
    11
    Location:
    South Africa, PRETORIA
    Hi Brainf51

    Nothing on there, already try there.

    Wyan
     
  4. btamas

    btamas Member

    Joined:
    Mar 15, 2009
    Messages:
    39
    Location:
    Szombathely, Hugary
  5. wyan

    wyan New Member

    Joined:
    Aug 11, 2009
    Messages:
    11
    Location:
    South Africa, PRETORIA
    Thanks, but again no wiring detail that I can trouble shoot the current problem.
     
  6. TimG

    TimG Member

    Joined:
    Nov 14, 2011
    Messages:
    69
    Location:
    Romsey, Hampshire
    Club:
    Southampton Buccaneers
    You may find it is not an electronics problem but dirty sensors which has been discussed quite a lot on the Daystate forum.
    Hope that helps.
     
  7. kimh

    kimh New Member

    Joined:
    Sep 20, 2010
    Messages:
    3
    Location:
    Eynsham, Oxfordshire
    problem...

    what's the problem, details please
     
  8. wyan

    wyan New Member

    Joined:
    Aug 11, 2009
    Messages:
    11
    Location:
    South Africa, PRETORIA
    The chrony stop working, then the shooter clean them without removing them, didnt help. Then the shooter remove everything to clean, but dont know how to connect the wires back to test (didnt make any note or marks anything). He then ask me for help due to my electronic back ground. I clean everything but need to know what is theoutput voltage on the connector where the chrony connect to test and also how the wires from chrony need to be connected to connector block on interface card.
     
  9. Pete m

    Pete m New Member

    Joined:
    Feb 9, 2011
    Messages:
    104
    Location:
    Nuneaton
    Club:
    Greyhound
    I have advised on the DOC to contact Tony B at Daystate
     
  10. wyan

    wyan New Member

    Joined:
    Aug 11, 2009
    Messages:
    11
    Location:
    South Africa, PRETORIA
    Pete M already done, waiting for feedback, three weeks or even more
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice