Chair GunPro Question. Expert Needed.

Discussion in 'General Airgun Chat' started by Alcanara, Oct 11, 2013.

  1. Alcanara

    Alcanara Member

    Joined:
    Oct 25, 2012
    Messages:
    194
    Location:
    Harrogate (HG2 7SR) & Murcia, Spain. (30840)
    Can you help??

    I do not seem to be able to change the units on the Range axis on the ballistics Table.

    I only seem to be able to get the default which is in units of 5.

    I would prefer a smaller gap so I can read off the clicks at various distances....Can you help.

    I know this is only a guide but it does help when you are doing the actual shooting tests.

    Thank you for your help.

    Cheers
    Stuart
     
  2. wiseguy

    wiseguy Active Member

    Joined:
    Apr 28, 2010
    Messages:
    337
    Location:
    Leende, NL
    Club:
    DFTA
    Right click in the table, choose "show every"
    Regards,
    Rob
     
  3. Alcanara

    Alcanara Member

    Joined:
    Oct 25, 2012
    Messages:
    194
    Location:
    Harrogate (HG2 7SR) & Murcia, Spain. (30840)
    Cheers Rob..... I have a mac and therefore a right click is not obvious.... But I should have thought of that.

    many thanks..... I love this site.

    Cheers

    Stuart:):)
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice