Air Arms cylinder strip down

Discussion in 'General Airgun Chat' started by paul4be, May 27, 2013.

  1. paul4be

    paul4be Why do I bother????????

    Joined:
    Feb 22, 2011
    Messages:
    1,165
    Location:
    Richmond, North Yorkshire
    Club:
    Darlington RA
    I am looking at renewing the cylinder on one of my pro targets.
    I am going to fit a new front end plug as well due to some edge damage to the current one. Due to cost, I would like to re-use the rear end plug assembly if possible.
    Is there a trick to getting them out without marking the alloy surface?

    Just don't want to find out that it won't move and I should have just ordered new anyway (although it's not cheap!!). I have grip straps etc.

    Thanks
     
  2. paul4be

    paul4be Why do I bother????????

    Joined:
    Feb 22, 2011
    Messages:
    1,165
    Location:
    Richmond, North Yorkshire
    Club:
    Darlington RA
    Any ideas??
     
  3. steve73

    steve73 New Member

    Joined:
    May 30, 2013
    Messages:
    11
    Location:
    Abertillery
    my two penneth worth

    ok so as I see it how to grip cylinder to strip down?
    this is what I used to do my ev2 recently
    hope this helps took me a while to post regards
    by the way going to treetops Thursday 6th for session any one going
     

    Attached Files:

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice